Step 1
|
Measure size of book and cover with paper of choice. Tear coordinating paper and place on bottom.
|
Step 2
|
Cut a strip from the Metal Accent Sheet and apply Rub ‘n Buff® with paper towel. Allow to dry slightly, then buff off some of the
color. Peel off backing paper and apply strip over torn paper to cover.
|
Step 3
|
Scratch surface of ArtEmboss® Light Aluminum with sandpaper, going in all directions. Apply Rub ‘n Buff® to metal. Apply colored
ink in same manner. Gently sand again to remove some of the color and highlight spots.
|
Step 4
|
Place metal upside down on flat surface. Place frame in center and trim to size. Notch corners. Fold all sides up. Cut a hole in center
and press metal towards back. Add photo.
|
Step 5
|
Turn over. Use stylus to emboss any desired pattern such as the palm trees shown. Apply double stick tape to back. Remove backing
and place onto front of journal as desired.
|
Step 6
|
Shape letters from 1/16" WireForm® WireRod Modeling Wire. Place on double stick tape. Hammer until somewhat flat. Cut tape out
around letters if possible. Place letters where desired.
|
Step 7
|
Measure an 18" length of WireForm® WireRod Modeling Wire and cut. Coil both ends with pliers. Coil ends of remaining length.
Find center point and create a loop. Secure easel back to loop by wrapping with FunWireTM. Wrap FunWireTM around easel back
above the coil. Wrap opposite end around easel front of coil. Adjust easel to sit correctly and hold journal.
|
Metal Accented Themed Journal
Contact Us
