Designer’s Note: This project can also function as a photo or place card holder.
Step 1
|
Condition clay by warming it in your hands or fold and roll it through pasta machine until it is soft and pliable.
|
Teacup
Step 2
|
Using 3/4 package of FIMO® Classic Magenta, roll a ball then flatten with palms of your hands until it is 1/2" thick and shaped
according to teacup pattern. Place a thin layer of transparent on the top part of the teacup.
|
Flower
Step 3
|
Roll five 1/4" balls from Orange FIMO® Classic and shape into teardrops. Make an indentation mark in center of each with needle
tool for petals. Wrap a very thin log of Red clay around each teardrop outlining it. Place points of teardrops together in a circle
and press a 1/4" flattened Red clay ball in center. Press a tiny Yellow ball into center of Red ball. Press flower onto center of teacup
front.
|
Leaves
Step 4
|
Roll Light Turquoise FIMO® Classic into two 1/4" balls. Shape into teardrops. Make indentation for veins. Press a small thin log of
Green clay in the center for veins. Outline the leaf with a thin Green log of clay. Press one leaf to each side of flower. Shave off
tiny pieces of White clay and roll between fingers and press onto teacup creating polka-dots.
|
Base
Step 5
|
Roll Orange clay into a 3/4" ball. Shape into a teardrop and press rounded edge onto flat surface. Wrap the bottom with a log of
Golden Yellow FIMO® Classic. Place a toothpick through center of base and press teacup over toothpick to secure.
|
Step 6
|
For the handle, roll Light Turquoise clay into a 1/4" by 2" log. Place tiny Green dots onto log. Bend log into desired shape for
handle and press onto right side of teacup.
|
Step 7
|
Flatten Magenta clay using the #3 setting on pasta machine or approximately 1/8". Cut a 2" circle. This is the saucer.
|
Step 8
|
To create stripes, flatten Black and White clay to equal thickness, approximately 1/8", and trim. Stack Black on top of White and
cut in half. Stack again and repeat this step. Roll a thin log of any color. Slice the striped clay very thin and wrap around log so
that stripes are vertical. Wrap striped log around top of teacup and around Magenta saucer. Place teacup in center of saucer.
|
Step 9
|
Shape wire according to your taste and press ends into top (center) of teacup to create the “steam effect”.
|
Step 10
|
Place on an index card, propping where necessary with glasses etc., to prevent it from falling over. Bake in a pre-heated oven at
265°F, 130°C for 30 minutes. Remove from oven when cool.
|
Teacup Recipe Card Holder
Contact Us
