Step 1
|
Tint FIMOŽ Metallic Pearl clay by adding a small amount of Translucent Yellow. Repeat with Metallic Pearl and Metallic Purple until you achieve the desired pastel colors (approximately 1 part color to 10 parts pearl).
Following the directions included in the AMACOŽ Tri Bead Roller, measure enough clay to form six small, round beads of each of the three colors (pastel yellow, lilac and pearl).
|
Step 2
|
Form one end of each bead to fit inside the bead caps. Using the eye-pin, pierce the bead through the center hole of the bead cap until the eye-pin is visible through the center of the opposite side.
|
Step 3
|
Following the lines as shown in Diagram A, place the AMACOŽ Needle Tool lengthwise over the center hole, making impressions across the bottom to form the bud shaped petals.
|
Step 4
|
Remove the eye-pins and set aside. Bake the beads on the AMACOŽ Professional Bead Baking Rack according to package instructions.
|
Step 5
|
Make six very tiny balls of each of your three custom FIMOŽ colors. Using a tiny yellow ball on the white beads, a tiny purple ball on the yellow beads and tiny white ball on the purple beads, place them in the center hole of each bead as shown in Diagram B. Attach each ball with a small drop of poly bonder adhesive. Bake again according to package instructions. If any of the bead caps are loose you can secure them with a small drop of poly bonder adhesive.
|
Step 6
|
(Optional) At this point you may want to "wet sand" any little imperfections in the clay (fingerprints, etc.) using a super fine grit sandpaper or sponge.
|
Step 7
|
(Optional) Apply several THIN coats of future acrylic floor polish to each bead using a fine bristle paintbrush. Allow beads to dry 20 minutes between coats. For an even more brilliant shine, you can then place them in a warm oven (200 degrees) for ten minutes.
|
Step 8
|
Using wire cutters, cut the eye-pin length to fit into the pre-made holes as shown in Diagram C, so the eye-pin is flush with the top of each bead. Use poly bonder adhesive or super glue to secure the eye-pins in place. Insert eye-pins and attach in the pre-made holes so they are flush with the top of each bead.
|
Step 9
|
Using 6mm jump-rings, attach beads to the bracelet alternating colors with one bead on every other link.
|
Crocus Charms Bracelet
Contact Us
